Oricom CARE80 Manuale Utente

User GuideCARE80Amplied Phone with direct dial picture buttonsPlease keep this user guide for future reference.TMCare80 user manual.indd 3 2009-11-

8OperationRecall and call waitingPress the Recall button followed by the extension number to transfer calls when connected to a PBX.Access to addition

9OperationVolume ControlReceiver volume controlThe receiver volume control enables you to adjust the receiver volume on the handset. Press the BOOSTb

10MemoryMemoryThe telephone has 6 one-touch and 10 two-touch memories for frequently dialed telephone numbers.When a number is stored into Memory you

11Consumer Support and TroubleshootingConsumer Support and TroubleshootingIf you feel this product is not working correctly please consult this u

12Consumer Support and TroubleshootingIt is important that you read the Warranty Card as it contains full and additional details of the warrant

TMCare80 user manual.indd 13 2009-11-5 17:38:03

Customer SupportEmail: [email protected]: Australia www.oricom.com.au New Zealand www.oricom.co.nz Phone: (02) 4574 8888Fax: (02) 4574 8898Au

TMCare80 user manual.indd 2 2009-11-5 17:37:59

1Table of contentsGeneral Information ...2Installation ...

2General InformationGeneral InformationWARNINGIt is very important that you read the User Guide carefully as it contains detailed information

3General InformationNotes for operation in New ZealandThe grant of a Telepermit for any item of terminal equipment indicates only that Telecom has acc

4InstallationInstallationConnecting the telephone1. Plug one end of the telephone cable supplied into the TEL. LINE jack at the back of the telephone

5InstallationMethod B. Attach directly to a wall1.Drilltwoholesvertically,oneabovetheother,83mmapart,andleavethe screws protruding from t

6Location of ControlsLocation of Controls1. Hook switch2. Handset holder3. Coil cord socket4. Receiver volume controller5. Storebutton6. Teleph

7OperationOperationRecall switch SettingFor Australia the Recall switch should be set to 100.For New Zealand the Recall switch should be set to 600.Ma